If you have an HP computer, you may have seen the error code ‘BIOHD-4’. This error can be caused by a few different things, but luckily there are a few simple ways to fix it. In this article, we’ll show you how to fix error code ‘BIOHD-4’ on your HP computer.
How to Fix Error Code ‘BIOHD-4’ on HP Computer
What is Error Code ‘BIOHD-4’?
Error Code ‘BIOHD-4’ is an error that can occur on HP computers. This error code indicates that there is a problem with the hard drive. This can be caused by a variety of things, such as a bad sector on the hard drive, a corrupted file, or a problem with the hard drive controller.
3) How to Fix Error Code ‘BIOHD-4’
There are a few things that you can try in order to fix this error. First, you can try running a disk check in order to repair any bad sectors on the hard drive. You can also try using a disk repair utility to fix any corrupted files. Finally, you can try updating the drivers for the hard drive controller.
How to Fix Error Code ‘BIOHD-4’?
If you’re receiving the error code ‘BIOHD-4’, it typically means there is an issue with the hard drive of your HP computer. To fix this error, you can try a few different things:
1) Restart your computer and see if the error persists. If it does, then try one of the following solutions.
2) Check to see if there are any updates available for your BIOS. If there are, install them and restart your computer.
3) Run a hard drive diagnostic tool to check for any errors with your hard drive. If any are found, try to repair them.
4) If you’re still receiving the error code ‘BIOHD-4’, it’s likely that your hard drive needs to be replaced.
Resources:
If you are receiving the error code BIOHD-4, it means that there is a problem with the hard drive on your HP computer. There are a few different ways that you can fix this error code.
One way to fix the error is to run a hard drive diagnostic test. This can be done by going into the BIOS on your HP computer and looking for the hard drive diagnostic tool. Once you have found the tool, run the diagnostic and see if it finds any errors. If the diagnostic does not find any errors, then you can try another method to fix the error.
Another way to fix the error is to format the hard drive and reinstall the operating system. This will erase all of the data on the hard drive, so make sure to back up any important files before doing this. To format the hard drive, go into the BIOS and find the option to format the hard drive. Once the hard drive has been formatted, you can reinstall the operating system.
If you are still receiving the error code BIOHD-4 after trying these methods, then you may need to replace the hard drive. You can either buy a new hard drive and install it yourself, or you can take the computer to a service center and have them replace the hard drive for you.

Must Read
1. Restart your computer and enter the BIOS setup utility.
2. Go to the Storage tab and set the SATA controller to AHCI mode.
3. Save your changes and restart your computer.
4. Uninstall any security software that may be causing interference.
5. Update your motherboard and storage controller drivers.
6. Run a hard drive diagnostic tool to check for any errors.
7. Reinstall Windows if all else fails.
Conclusion:
The error code ‘BIOHD-4’ on an HP computer can be fixed by reverting back to the last known good configuration, uninstalling any new programs or drivers that may be causing the issue, and running a virus scan. If the problem persists, contact HP customer support for further assistance.